
Stainless Steel Pre-Coiled Cable Nozzle Heater, up to 650 °C and 23.5 W/cm²
A cable nozzle heater with a pre-coiled element that wraps the nozzle and heats it evenly around the full circumference. The stainless steel sheath works up to 650 °C, with a maximum surface watt density of 23.5 W/cm² and a 5 in. unheated tail.
- Type
- Cable nozzle heater, pre-coiled
- Heating
- Full 360° around the nozzle
- Sheath material
- Stainless steel
- Insulation
- Compacted magnesium oxide (MgO)
Price, availability and lead time on request. We help with analogue selection, customs clearance and delivery.
Description
This heater is built to warm nozzles and other cylindrical parts onto which the coil is slipped directly. The cable is wound at the factory into a tight coil with a small pitch, so the heater takes up little space on the nozzle and delivers heat evenly all round, through the full 360 degrees.
The heating element uses cable technology. A conductor is insulated with magnesium oxide (MgO) and enclosed in a stainless steel sheath. During manufacture the sheath is reduced by rotary swaging, which compacts the MgO insulation more tightly than rolling and turns it into a solid mass. This dense insulation conducts heat well and withstands the working voltage at high temperature, so heat passes quickly from the conductor to the sheath.
At the outlet end the heater has an unheated tail of 5 in. (127 mm). This moves the connection zone away from the hot coil and prevents failures at the transition caused by overheating. The transition is the most heavily loaded point on cable heaters, where the lead meets the heated sheath.
The maximum working temperature is 650 °C (1200 °F), the top of its range. The top surface watt density is 23.5 W/cm², equal to 152 W/in². When sizing, watt density is matched against heat removal conditions: the poorer the contact between coil and nozzle and the higher the part temperature, the lower the watt density chosen so that the sheath does not overheat.
This heater belongs to the nozzle heater family. Coil diameter, length, power, voltage and type of leads are set for each individual nozzle, so an enquiry needs the part dimensions, the required power and the mains voltage.
Technical specifications
| Type | Cable nozzle heater, pre-coiled |
|---|---|
| Heating | Full 360° around the nozzle |
| Sheath material | Stainless steel |
| Insulation | Compacted magnesium oxide (MgO) |
| Manufacturing | Rotary swaging |
| Maximum operating temperature | 650 °C (1200 °F) |
| Maximum watt density | 23.5 W/cm² and 152 W/in² |
| Unheated tail | 5 in. (127 mm) |
| Family | Nozzle heaters |
Request a price and lead time
Stainless Steel Pre-Coiled Cable Nozzle Heater, up to 650 °C and 23.5 W/cm². We reply within one business day.
Or email sales@usk.ua or call 044 339-50-20.
Questions and answers
What is the unheated tail section for?
The 127 mm tail moves the lead connection away from the hot coil and prevents transition failures caused by overheating.
What are the working temperature and watt density limits?
The working temperature reaches 650 °C (1200 °F), and the surface watt density is 23.5 W/cm² and 152 W/in².
What information is needed to select the heater for a nozzle?
The coil diameter, length, power, voltage and type of leads depend on the nozzle, so an enquiry needs the part dimensions, the required power and the mains voltage.
Similar equipment from other manufacturers






