International supply. Engineering expertise.
office@usk.ua09:00–18:00 · Kyiv

HIX two-wire loop-powered signal isolator and repeater with HART pass-through

The HIX is a two-wire repeater isolator powered from the current loop that carries HART data through. It splits one measurement signal between a primary and a backup control system, so work on one loop does not disturb the other.

Type
current signal isolator and repeater
Circuit
two-wire, loop-powered
Protocol
HART pass-through
Isolation
separation of primary and secondary loops

Price, availability and lead time on request. We help with analogue selection, customs clearance and delivery.

Description

The HIX is needed when the signal from one sensor must reach a primary controller and a backup system at the same time, as happens in data centres and oil and gas facilities. In a data centre, temperature and humidity are watched continuously. Low humidity raises the risk of electrostatic discharge that damages electronics, while high humidity can bring condensation, corrosion and short circuits inside the servers. These signals usually have to go to several receivers.

Wiring several receivers in series into one loop is risky, because a fault or break in any one device opens the whole loop and every consumer loses the signal. The HIX sits between the primary and secondary loops. It provides galvanic separation and repeats the input signal at its output, so maintenance or a fault on the backup side does not affect the primary loop, and the reverse is also true.

The isolator is two-wire and draws its power from the loop itself, so no separate supply is required. It passes digital HART data alongside the analogue signal, so the backup system receives both the process variable and the diagnostic information from the field device. If the input fails, the HIX follows the failure and drives its output below 3 mA, so the receiver clearly sees a break or a sensor fault. It is approved for Class I Div 2 and Zone 2, which means it can be installed in the corresponding hazardous areas.

When ordering, the input signal parameters, the number of receivers, the mounting location (control cabinet or field zone) and whether HART data must reach the backup system should be specified.

Technical specifications

Typecurrent signal isolator and repeater
Circuittwo-wire, loop-powered
ProtocolHART pass-through
Isolationseparation of primary and secondary loops
Response to input failureoutput below 3 mA
ApprovalsClass I Div 2/Zone 2

Part numbers

Show all part numbers (1)

HIX

Request a price and lead time

HIX two-wire loop-powered signal isolator and repeater with HART pass-through. We reply within one business day.

* — required fields

Or email sales@usk.ua or call 044 339-50-20.

Questions and answers

Does the HIX need a separate power supply?

No. The isolator is two-wire and is powered from the current loop.

Does HART data pass through the isolator?

Yes. The HIX carries HART data alongside the analogue signal, so the backup system receives it too.

How does the isolator behave if the sensor wire breaks?

It follows the input failure and drives its output below 3 mA, which the receiver recognises as a fault.

Similar equipment from other manufacturers

LET’S CONNECT

Let’s start with your challenge.

Complete a short brief. We will prepare an email you can send from your own email app.

Call us044 339-50-2009:00–18:00
USK ENERGY / SEARCH

Search

Solutions, specialist directions and guides