International supply. Engineering expertise.
office@usk.ua09:00–18:00 · Kyiv

Dielectric Rubber Goods Washer and Dryer, RGW-2C and RGW-2 Models

The set washes and dries dielectric rubber protective equipment, combining a 316 stainless steel drum washer (RGW-2C or RGW-2) with a static dryer for gloves, sleeves and other rubber goods. It is used before and after electrical testing.

Washer models
RGW-2C (automatic PLC control), RGW-2 (manual control panel)
Drum size
559 mm diameter × 2134 mm length, or 762 mm diameter × 2438 mm length
Drum material
316 stainless steel
Drum speed
25 rpm

Price, availability and lead time on request. We help with analogue selection, customs clearance and delivery.

Description

The washer and dryer form part of a laboratory where dielectric rubber protective equipment is tested electrically. Gloves, sleeves, overshoes, blankets, hoses, hoods and boots are tested at a voltage above their maximum working level, so they are washed before testing and dried afterwards without mechanical damage.

The washer has a rotating drum made entirely of 316 stainless steel, turning at 25 rpm so that rubber goods are not abraded or damaged. It comes in two sizes, with diameters of 559 mm or 762 mm and lengths of 2134 mm or 2438 mm, and the drum is reached through two light latched doors. The drive runs through a chain and gearbox, and the unit operates quietly.

The RGW-2C has automatic control through a programmable logic controller, while the RGW-2 uses a manual control panel. Both run from a 120 or 240 V AC single-phase supply at 50/60 Hz on continuous duty. Standard fittings include a main power switch, a washing chamber interlock, an inlet water cartridge filter, a hot water recirculation pump, automatic filling, a timed wash and rinse cycle with an audible signal, step rotation of the drum, a brass drain valve and waterproof push buttons.

The dryer is a static cabinet. Items are laid on five corrosion-resistant racks set at a slope so that water runs off, and 50 fans of 100 CFM each, ten per rack, move hot air around them. Unlike a drum dryer, items are not pinched or torn. A 10 kW heater with an output of 35,000 BTU sits at the top of the cabinet, and a 665 CFM exhaust fan removes moisture and heat.

The cabinet is made from 12 gauge steel with a primed and painted finish and a stainless steel floor, and its doors are transparent for inspection. Controls include a circuit breaker, start and stop buttons, indicator lamps, a digital thermostat with upper and lower set points, a digital timer for the heating cycle and programmable heater control. The dryer weighs 455 kg and measures 2050 × 1310 × 2245 mm. Both units operate at 10 to 40 °C indoors or outdoors in fair weather, with humidity below 95% non-condensing and altitude below 1000 m. The washer needs a level concrete floor with a drain and a hot water supply at about 40 psi.

Technical specifications

Washer modelsRGW-2C (automatic PLC control), RGW-2 (manual control panel)
Drum size559 mm diameter × 2134 mm length, or 762 mm diameter × 2438 mm length
Drum material316 stainless steel
Drum speed25 rpm
Washer supply120 or 240 V AC, single phase, 50/60 Hz
Duty cyclecontinuous
Dryer capacity50 gloves, or 50 sleeves, or 70 overshoes, or 12 blankets, or 35 hoses, or 25 hoods
Dryer supply208/240 V AC, 60 Hz, single phase
Dryer rating10 kW, 35,000 BTU
Dryer fans665 CFM exhaust fan; 50 circulation fans at 100 CFM each
Racks5 corrosion-resistant racks, sloped for drainage
Dryer dimensions2050 × 1310 × 2245 mm
Dryer weight455 kg
Operating conditions10 to 40 °C, humidity below 95% non-condensing, altitude below 1000 m

Part numbers

Show all part numbers (2)

RGW-2C, RGW-2

Request a price and lead time

Dielectric Rubber Goods Washer and Dryer, RGW-2C and RGW-2 Models. We reply within one business day.

* — required fields

Or email sales@usk.ua or call 044 339-50-20.

Questions and answers

What is the difference between the RGW-2C and the RGW-2?

The RGW-2C has automatic PLC control, while the RGW-2 is run from a manual control panel. The drum, material and supply are the same.

How many items does one dryer load hold?

One load holds 50 gloves, or 50 sleeves, or 70 overshoes, or 12 blankets, or 35 hoses, or 25 hoods.

What does the washer need from the site?

A level concrete floor with a drain, a hot water supply at about 40 psi, and a 120 or 240 V AC supply.

Similar equipment from other manufacturers

LET’S CONNECT

Let’s start with your challenge.

Complete a short brief. We will prepare an email you can send from your own email app.

Call us044 339-50-2009:00–18:00
USK ENERGY / SEARCH

Search

Solutions, specialist directions and guides