International supply. Engineering expertise.
office@usk.ua09:00–18:00 · Kyiv

TECNA TSW1000CAR capacitor discharge stud welder for car body repair, 1 kVA

The TECNA TSW1000CAR belongs to the TSW series and is intended for body repair, where it welds studs and threaded pins of ferrous and non-ferrous metals onto thin sheet. The discharge lasts 2-3 ms and the reverse side of the sheet is left unaffected.

Brand
TECNA
Country of manufacture
Italy
Series
TSW
Model
TSW1000CAR

Price, availability and lead time on request. We help with analogue selection, customs clearance and delivery.

Description

Within the TSW series, the TSW1000CAR has the same 1 kVA rating as the senior model, and according to the manufacturer's page it works on the same principle. The page does not set out the differences between the two, so when choosing a unit for particular stud diameters and materials it is wise to check TECNA's documentation.

The principle is capacitor discharge. The unit draws a small current from the mains and charges a capacitor bank in a few seconds, then delivers all the stored energy into the stud in a very short discharge of about 2-3 ms. This is enough to weld elements of ferrous and non-ferrous metals up to 8 mm ø. Despite the catalogue name Aluminium Spotter, the unit works with both steel and aluminium elements.

For a body repair technician the key point is that the discharge is very short and local. Studs, threaded pins and other fixings are fitted to thin panels from the front, with no trim removal and no restoration of the protective layer inside the panel, because a painted or galvanised surface on the opposite side stays intact.

A microprocessor control unit monitors the mains and compensates for voltage fluctuations, so the discharge repeats with the same energy. LED indicators show operating modes and diagnostics, so the status of the unit and any possible fault can be seen at once without going through a menu. The unit has forced fan cooling, a protective device and fault protection. In the TECNA catalogue it sits in the body technology section next to the other spotters. The manufacturer is TECNA, based in Italy.

Technical specifications

BrandTECNA
Country of manufactureItaly
SeriesTSW
ModelTSW1000CAR
Typecapacitor discharge stud welder (Aluminium Spotter)
Power1 kVA
Element diameterup to 8 mm ø
Discharge durationabout 2-3 ms
Materialsferrous and non-ferrous metals
Controlmicroprocessor, with mains fluctuation compensation
IndicationLED, diagnostics
Coolingforced fan

Part numbers

Show all part numbers (1)

TSW1000CAR

Request a price and lead time

TECNA TSW1000CAR capacitor discharge stud welder for car body repair, 1 kVA. We reply within one business day.

* — required fields

Or email sales@usk.ua or call 044 339-50-20.

Questions and answers

Can the TSW1000CAR weld aluminium studs?

Yes. The unit welds elements of ferrous and non-ferrous metals up to 8 mm ø.

Does the paint on the reverse side of the panel need removing?

No. A painted or galvanised surface on the opposite side of the panel stays unchanged.

How is the unit cooled?

By forced fan ventilation. It also has a protective device and fault protection.

Similar equipment from other manufacturers

LET’S CONNECT

Let’s start with your challenge.

Complete a short brief. We will prepare an email you can send from your own email app.

Call us044 339-50-2009:00–18:00
USK ENERGY / SEARCH

Search

Solutions, specialist directions and guides